CAT5E and CAT6 Patch Panels 
Our CAT.5e patch panels are used for high speed Lan's transmission rates up to 155Mbps, these patch panel was developed with a proprietary printed circuit board technology which
results in performance to meet EIA/TIA 568A Category 5E Enhanced specifications. The new version of 110D terminal block can be used for both "Krone & 110" tool, and has 568B and
568A color codes both on the top of new version 110D IDC for easy installation. New 45 Angle Jack Bracket sets for plug inserted to save space and snap them onto front panel at
Non-Screw via good view, such provides function to be required on color coding identification for LAN system.
Our CAT.5e Shielded patch panel is used for high speed LAN's transmission rates up to 100Mbps, the patch panel was
developed with a proprietary printed circuit board technology which results in performance to meet EIA/TIA 568A Category 5E
Enhanced Specifications. The fully shielded patch patch panel has termination blocks of Krone (8 pins a snap ground pin for
drain wire) and new version of 110D (9 pins IDC, drain wire punch into pin 9th) For all types of IDC have color code according to EIA/TIA 568A printed on the top for easy inatallation.
1.Full shielded RJ45 jack
2.A.9 Pin of New Terminal Block: Combine 2 wiring print of T568A & B to save one stock, drain
wire should be punch down into pin 9th (grounded)
B.8 pin Krone Terminal Block: Combine 2 wiring print of T568A & B to save one stock.
3.Snap Ground Pin (Only for Krone terminal block): Insert drain wire and push toolless cap to
contact.
4.Cable Holder: Press foil or braid shielded to contact ground, and keep the cable straight.
5.Cable Clip Screw: To hold the cable tightly by screws for two cables at one time.
6.For Cable Tie: Optional required by stronger security.
7.Port Numbering: Identify the exact port numbering on the back side, easy and effective
installation.
|
